1. Remove Top Shelf:

If the top shelf, which is located below the water filter, is in the highest position, it will need to be removed. This can be done in two simple steps:

• Tilt up the front of the shelf and lift it.
• Pull the shelf out.

2. Remove Old Filter:

Pull the water filter downward and turn it counter-clockwise to pull it out. Make sure to rotate the filter down completely before pulling it out of the manifold hole.

3. Install New Filter:

Take a new water filter out of its packaging and remove the protective cover from the o-rings. With the filter tabs in the horizontal position, push the new filter into the manifold hole, rotate it up into place, and close the cover.

4. Remove Trapped Air:

Now that the filter is replaced, dispense 2.5 gallons of water to remove trapped air and contaminants from the system. Depress and release the dispenser pad for cycles of 30 seconds ON and 60 seconds OFF, rather than dispensing continuously.

5. Reset Water Filter Indicator:

Replace the water filter when the replace filter icon turns on. After replacing the water filter, press and hold the Water Filter button for three seconds to turn the icon light off.

NOTE: Replace the water filter approximately every six months. Sample image displayed of panel may differ on various models.